Spektrum DX6i Bedienerhandbuch PDF herunterladen (Seite 7)

7SPEKTRUM DX6i • RADIO INSTRUCTION MANUAL

BINDING

You must bind the receiver to the transmitter before it will operate. Binding is sharing identication codes between the receiver and

the active memory of the transmitter. Once bound, the receiver only connects to the transmitter when the previously bound model

memory is selected. You will need to rebind after the model is set in the transmitter to fully program the model’s failsafe positions. If

another model memory is selected, the receiver will not connect. This feature is called ModelMatch™ and prevents ying a model

using the wrong model memory.

HOLD SWITCH WHILE POWERING ON

Mode 2 Shown

1. 2. 3.

4. 5. 6.

HOLD SWITCH WHILE POWERING ON

Mode 2 Shown

Binding using receiver and receiver battery

Binding using receiver and ESC

HOLD SWITCH WHILE POWERING ON

Mode 2 Shown

1. 2. 3.

4. 5. 6.

HOLD SWITCH WHILE POWERING ON

Mode 2 Shown

1. Lower throttle to lowest position and make sure the

transmitter is powered off

2. Insert bind plug into BATT/BIND (BIND/DATA) receptacle.

3. Insert receiver battery into ANY open receptacle.

Note: The receiver’s LED ashes when the receiver is ready to

bind.

4. While holding Trainer/Bind switch, power on transmitter.

5. Keep hold on trainer switch until receiver’s LED stays

illuminated; this indicates the receiver is bound to the

transmitter.

6. Remove bind plug from receiver.

1. Lower throttle to lowest position and make sure the

transmitter is powered off

2. Insert bind plug into BATT/BIND (BIND/DATA) receptacle.

3. Insert ESC plug into THRO receptacle.

4. Connect battery to ESC and turn on ESC switch, if available.

Note: The receiver’s LED ashes when the receiver is ready to

bind.

5. While holding Trainer/Bind switch, power on transmitter.

6. Keep hold on trainer switch until receiver’s LED stays

illuminated; this indicates the receiver is bound to the

transmitter.

7. Remove bind plug from receiver.

1 2 3 4 5 6 7 8 9 10 11 12 ... 25 26

Kommentare zu diesen Handbüchern

Keine Kommentare

Spektrum DX6i Bedienerhandbuch Seite 7

Kommentare zu diesen Handbüchern