Spektrum SPMAR6260 Betriebsanweisung PDF herunterladen (Seite 15)

drops below the low voltage threshold (3.5 volts), the DSM receiver must

reboot (go through the start-up process of scanning the band and ﬁnding

the transmitter) and this can take several seconds.

4. Q: Sometimes my receiver loses its bind and won’t connect requiring

rebinding. What happens if the bind is lost in ﬂight?

A: The receiver will never lose its bind unless it’s instructed to. It’s important to

understand that during the binding process the receiver not only learns the

GUID (code) of the transmitter but the transmitter learns and stores the type

of receiver that it’s bound to. If the transmitter is put into bind mode, the

transmitter looks for the binding protocol signal from a receiver. If no signal

is present, the transmitter no longer has the correct information to connect

to a speciﬁc receiver and in essence the transmitter has been “unbound”

from the receiver. We’ve had several DX7 customers that use transmitter

stands or trays that unknowingly depress the bind button and the system

is then turned on losing the necessary information to allow the connection

to take place. We’ve also had DX7 customers that didn’t fully understand

the range test process and pushed the bind button before turning on the

transmitter also causing the system to “lose its bind.”

If the system fails to connect, one of the following has occurred:

• The transmitter is near conductive material (transmitter case, truck bed,

etc.) and the reﬂected 2.4GHz energy is preventing the system from

connecting. (See 2nd question above)

• The transmitter was put into bind mode knowingly (or unknowlingly)

causing the transmitter to no longer recognize the receiver.

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 21 22

Keine Kommentare

Spektrum SPMAR6260 Betriebsanweisung Seite 15